Preview of MSPub built website has different fonts than .pub doc

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

bsimpson5 - 18 Oct 2006 15:10 GMT

When I view a web preview of my site built in MSPublisher, the fonts and
layouts are different from those contained in the .pub document. The fonts
appear to be the same as those in the original Word doc that I used to build
my page in Publisher. I changed them in the Publisher document, but those
changes don't show up in the web preview.

Any ideas?

Reply to this Message

DavidF - 18 Oct 2006 15:35 GMT

Perhaps you are not using web safe fonts. Reference: Web safe fonts in
Publisher 2003 web publications
http://msmvps.com/blogs/dbartosik/archive/2006/01/06/81275.aspx

Also run the Design Checker under Tools to identify other possible problems
with your design.

DavidF

> When I view a web preview of my site built in MSPublisher, the fonts and
> layouts are different from those contained in the .pub document. The
[quoted text clipped - 5 lines]
>
> Any ideas?

Reply to this Message

bsimpson5 - 18 Oct 2006 23:37 GMT

Thanks for the ideas, but I still haven't gotten the issue worked out.
According to the reference document, the Trebuchet MS I'm using should be a
web safe font, and the design checker didn't reveal anything amiss. Is it
possible that the Trebuchet MS varies enough from Trebuchet (referenced in
the doc) to cause a problem? Or maybe the variations in font size I'm using
(7.1, 8.5, etc)?

Thanks!

> Perhaps you are not using web safe fonts. Reference: Web safe fonts in
> Publisher 2003 web publications
[quoted text clipped - 14 lines]
> >
> > Any ideas?

Reply to this Message

GeePee - 19 Oct 2006 09:18 GMT

I'm using MS Publisher 2003 and have had similar problems with the web
preview, however I went ahead and published the site and all was OK.
A couple of the problems were:-
graphics appearing in the preview in a different position to where they were
actually placed.
text misaligned.
I don't know the reason but when I cleaned out all the old files related to
the site on my computer (I save each revision in a different folder in case I
wish to go back) and just preserved the current copy, then the preview
presented OK.
Graham

> Thanks for the ideas, but I still haven't gotten the issue worked out.
> According to the reference document, the Trebuchet MS I'm using should be a
[quoted text clipped - 23 lines]
> > >
> > > Any ideas?

Reply to this Message

DavidF - 20 Oct 2006 12:33 GMT

In addition to what Graham suggested, you can certainly try a different
font. However, I would guess that your problem is more to the odd size of
fonts you are using. When Publisher converts your text to HTML, it doesn't
know what to do with 7.1, 8.5 etc, and will round off those numbers. I
fairly certain that 8.5 will be rounded down to 8 as an example. I suspect
that you will need to change your text box size to accommodate even font
sizes; 6, 8, 10, 12 etc.

DavidF

> Thanks for the ideas, but I still haven't gotten the issue worked out.
> According to the reference document, the Trebuchet MS I'm using should be
[quoted text clipped - 28 lines]
>> >
>> > Any ideas?

Reply to this Message

Rate this thread: