I'm trying to figure out how to do something that I can easily do in
Adobe Framemaker. Basically, I want to have table/figure numbering
that has both the chapter (level 1) number and a standalone table/
figure number. For example:

I have a word document that has a few section breaks in it due columns for
formatting purposes.  When i attempt to number the pages...I get 1-4 (page 4
has my columns), NO page 5 and then the numbers start from 1 again on page 6.
I hit the format button when doing the numbering, ...

Has anyone else had this problem. It seems if I modify a multilevel
list style from the gallery on the home tab, chaos occurs (numbering
fails miserably, and it seems like the style disappers from the
gallery?), whereas if I modify the list style from the Style manager,

I having difficulty with my dissertation.  My paper is 133 pages long and I
need to use i,ii, iii for the first 9 pages of my paper and then start at
number 1 page for my first Chapter.  How do change the page number sequence?

We have recently upgraded to Office 2007.
I ihave a number of documents that use outline number style headings.
i.e.
1

I am working with a large Word document (330 pages) that is set up as
a master document with subdocuments. At the end there are a set of
four indexes--Geographical, People, Source, and Topical. I just
starting seeing an anomaly in one of the indexes that I cannot explain

Is it possible to go to a specific outline number in a word document?  The document has custom numbering if that makes  a difference.
Thanks for any help.
Koob

We are using a format in which caption numbers begin with the current heading
number, as in 3.4.1-1, 3.4.1-2, etc. If we then have appendixes A, B, and C,
using Heading 5 style, can we modify the figure captions to pick up the
letter from heading 5, in the same document?

I am writing a thesis that includes front-matter (disclaimer, preface,
etc.), several numbered chapters, and rear-matter (references,
appendices).  I am attempting to structure the document so that
numbering and table of contents is handled automatically.  The table

I am trying to figure out how to do one thing.  I need to print out numbers
that are about 10" in height.  I am wondering how I can do this because
there are no fonts that go that tall.
Thanks

I need each section of a manual to be a separate document. So I reset the
number of the Heading 1 at the start of each document, and the lower-level
headings pick it up correctly, except when I reopen the file, it has reset
back to 1.  How do I reset the number so that it lasts? ...

Word 2003
I am telling my page numbers to include the Heading 2 chapter number.  The
page numbers look fine (1.1-1, 1.1-2, etc.) but the Heading 1 level does not
show up correctly in the Table of Contents.  If Section 2.0 is on Page 2.1-1,